TB-500 guideDosing & ProtocolUpdated 2026-04-21

How often should you inject TB-500?

Quick Answer

TB-500 is typically injected twice weekly (2 mg per dose) during a 4–6 week loading phase, then once weekly (2 mg) for maintenance. This is much less frequent than BPC-157 (daily) because TB-500's longer half-life allows sustained tissue levels with weekly dosing.

Why TB-500 Doses Weekly and BPC-157 Doses Daily

The two peptides have very different pharmacokinetic profiles. TB-500 (a synthetic fragment of Thymosin Beta-4) has a longer effective half-life in tissue, and its mechanism relies on sustained baseline levels rather than rapid pulses. BPC-157 has shorter residence time and appears to act more as an ongoing healing signal that benefits from daily reinforcement.

This difference has practical consequences: TB-500 tends to be more tolerable because injection burden is lower, but the per-dose amount is larger.

Standard Loading Phase (Weeks 1–4 or 1–6)

  • Dose: 2 mg subcutaneously, twice weekly
  • Schedule: Commonly split Monday/Thursday or Sunday/Wednesday — any ~3–4 day gap works
  • Rationale: higher initial dose saturates tissue and produces faster onset of systemic effects
  • Duration: 4 weeks for most injuries; extended to 6 weeks for severe or extensive tissue damage

Standard Maintenance Phase (Weeks 5+)

  • Dose: 2 mg subcutaneously once weekly
  • Schedule: Same day each week for consistency
  • Duration: 4–8 weeks typical, then evaluate

Alternative Dosing Schedules

Higher-Dose Loading for Severe Injuries

  • 5 mg loading doses once weekly for 4 weeks
  • Used less commonly, requires careful clinician supervision
  • Higher cost per cycle

Lower-Dose Extended Maintenance

  • 1 mg weekly for extended maintenance
  • Used in long-term protocols where acute healing has completed
  • Less commonly seen in practice

Injection Site and Technique

  • Subcutaneous injection in abdomen, thigh, or upper arm
  • 29–31G insulin syringe
  • Rotate sites weekly
  • Avoid sites over active injuries during acute inflammation
  • Never inject TB-500 and BPC-157 in the same syringe

Reconstitution Notes

TB-500 arrives lyophilized and is reconstituted with bacteriostatic water per your compounding pharmacy's instructions. Common reconstitution:

  • 5 mg vial reconstituted with 1 mL bacteriostatic water = 5 mg/mL solution
  • 2 mg dose = 0.4 mL (40 units on 100-unit insulin syringe)
  • Reconstituted vial refrigerated, typically stable for 30 days

Timing Considerations

  • Time of day doesn't strongly matter — morning or evening
  • Can be administered with or without food
  • Don't inject within 24 hours of a competitive athletic event (both for WADA reasons and general recovery logic)

When to Deviate From Standard Schedule

  • Severe acute injury in a high-performing athlete — loading phase may be extended
  • Post-surgical recovery — typically starts 2 weeks post-op at maintenance dose
  • Patient intolerance of loading dose — reduce to 1 mg twice weekly during loading
  • Cost constraints — maintenance-only dosing is sometimes used for minor injuries

When to Stop

  • Full resolution of target injury
  • After 8–12 weeks with no meaningful response (unlikely to improve with longer cycle)
  • Any unusual systemic symptoms requiring evaluation
  • Before any cancer diagnosis workup
  • Before pregnancy attempts

See the TB-500 guide and Wolverine Stack dosage.

Related questions about TB-500

Find a TB-500 provider

Browse verified providers offering TB-500 therapy. Filter by telehealth, location, and insurance acceptance.

Browse providers

Medical Disclaimer: This content is for informational purposes only and should not be considered medical advice. Always consult with a qualified healthcare provider before beginning any peptide therapy treatment.